How to use #38

[andrew_rs225]

This might seem a simple question but how does I use Megs #38 Tyre dressing?
Got my sample from Clean and Shiny today and was surprised that it is quite a thick brown liquid.
Does it have to be diluted or do you just wipe it on or spray etc?

Thanks
Andrew

[Ant GTI-6]

Hi Andy

Apply #38 neat using a MF rapped round your finger for accuracy to all black/grey plastic trim etc, leave it 20-30 mins to soak in then buff with a clean MF. It is great stuff last ages and beads water superbly.

Ant

[andrew_rs225]

Thanks:thumb:

Hopefully I will get to clean the wheels properly and try it out at the weekend:D

Andrew

[WHIZZER]

Or try a piece of sponge cut down to the size of your tyre

[Solaar]

I've got a small brush wich I use to apply #38 with, works quite well.

[andrew_rs225]

Thanks for the suggestions. Used a cut down sponge in the end. Forgot to buff afterwards but still looks fine though. Good finish and much easier to apply than the spray foams I used previously.

[Ant GTI-6]

go to tesco and get the 14p pan scouer sponges the ones with the green scourer bit on, just use the reverse of these, at 14p your not loosing anything:thumb: great for applying endurance tyre dressing or#38:thumb:

Ant

[blr123]

Mike (extreme_valet) puts #38 on the sponge then adds endurance........never tried ot myself (don't have #38) but Mike likes it :thumb:

Bryan