Detailing World  

Go Back   Detailing World > Search Forums
DW Home Forum Home Merchandise Store Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Showing results 1 to 25 of 47
Search took 0.01 seconds.
Search: Posts Made By: BradleyW
Forum: Pre-wash stages, Washing, Drying, Clay & 'Quick Detailing' 20-06-2018, 12:12 PM
Replies: 3
Views: 287
Posted By BradleyW
Any cheap household APC for a £1 will do the job....

Any cheap household APC for a £1 will do the job. Spray on, leave to dwell, agitate with a brush and rinse off.
Forum: Polish/Cleaners/Compounds/Glaze 18-06-2018, 07:33 PM
Replies: 12
Views: 669
Posted By BradleyW
SRP does not have the level of cut required to...

SRP does not have the level of cut required to remove most defects. SRP uses fillers to hide swirl marks. The filling properties are very limited in my opinion. S20 when its worked correctly with a...
Forum: Waxes, Sealants & Paint Protection 18-06-2018, 07:11 PM
Replies: 23
Views: 1,428
Posted By BradleyW
If its on the Audi Official page, there's...

If its on the Audi Official page, there's probably a degree of Photoshop used, to aid marketing. This is only my opinion. As for a wet look, Scholl S40 is a good polish to try (with a polishing...
Forum: Waxes, Sealants & Paint Protection 18-06-2018, 07:06 PM
Replies: 3
Views: 297
Posted By BradleyW
They recommend that you apply it with the MF...

They recommend that you apply it with the MF towel and continue to wipe until clear. I've seen a few people on Youtube apply it as you would with a traditional wax, with good results.
Forum: Detailing Chat 18-06-2018, 06:30 PM
Replies: 12
Views: 576
Posted By BradleyW
Add clay bar and abrasive polish to the list of...

Add clay bar and abrasive polish to the list of things to try. Tar remover is probably your best bet as suggested above. I would recommend Autoglym Intensive Tar Remover.
Forum: Pre-wash stages, Washing, Drying, Clay & 'Quick Detailing' 18-06-2018, 06:10 PM
Replies: 18
Views: 858
Posted By BradleyW
TFR should do the trick if the bugs haven't been...

TFR should do the trick if the bugs haven't been left on the car for weeks on end. A good LSP will allow you to remove bugs easier. TFR can reduce the life of your LSP. Contact your LSP manufacturer...
Forum: Waxes, Sealants & Paint Protection 16-06-2018, 07:26 PM
Replies: 60
Views: 3,066
Posted By BradleyW
BH DSW. Easy to apply, durable, glossy, good...

BH DSW. Easy to apply, durable, glossy, good beading and sheeting! Extremely economical! Withstands detergents very well! Brilliant stuff! However it can haze on black cars if you apply too thick or...
Forum: Interior & Glass 16-06-2018, 07:21 PM
Replies: 4
Views: 568
Posted By BradleyW
There are no water based products which will...

There are no water based products which will offer anything thick enough to take the brunt of any mechanical abrasion. A physical material would be needed. Perhaps something similar to that of a car...
Forum: Waxes, Sealants & Paint Protection 16-06-2018, 07:12 PM
Replies: 60
Views: 3,066
Posted By BradleyW
Deleted.

Deleted.
Forum: The Showroom 16-06-2018, 06:54 PM
Replies: 3
Views: 743
Posted By BradleyW
Brilliant video mate!

Brilliant video mate!
Forum: Polish/Cleaners/Compounds/Glaze 14-06-2018, 05:23 PM
Replies: 3
Views: 433
Posted By BradleyW
You are better off using Hex Logic White. It has...

You are better off using Hex Logic White. It has a light cut which will aid in the removal of such defects quicker.
Forum: Pre-wash stages, Washing, Drying, Clay & 'Quick Detailing' 13-06-2018, 03:22 PM
Replies: 389
Views: 127,477
Posted By BradleyW
I've just used BSD on soft black paint today....

I've just used BSD on soft black paint today. Mist onto MF towel and wipe gently without pressure. Little to no smearing. It's perfectly fine to use on it's own. It just requires technique to get the...
Forum: Pre-wash stages, Washing, Drying, Clay & 'Quick Detailing' 12-06-2018, 06:40 PM
Replies: 8
Views: 798
Posted By BradleyW
It's a greater risk using a QD to wipe away dirt....

It's a greater risk using a QD to wipe away dirt. Less so with the full pre-wash / 2BM procedure. Light dirt in my opinion would be a thin layer of dust that's hard to see unless the car is in direct...
Forum: Polish/Cleaners/Compounds/Glaze 05-06-2018, 11:17 PM
Replies: 5
Views: 2,217
Posted By BradleyW
I'd have to disagree. On my car, the panel above...

I'd have to disagree. On my car, the panel above the front wheel has not been polished (applies for both sides of the car). This section was clay barred today. It was heavily contaminated. The other...
Forum: Polish/Cleaners/Compounds/Glaze 05-06-2018, 12:57 AM
Replies: 5
Views: 1,145
Posted By BradleyW
Scholl S17+ for medium defects. S30 or S40 for...

Scholl S17+ for medium defects. S30 or S40 for light correction. S40 gives a wet look, S30 for a lighter crisp look. Scholl use diminishing abrasives.
Forum: Polish/Cleaners/Compounds/Glaze 05-06-2018, 12:54 AM
Replies: 18
Views: 3,370
Posted By BradleyW
Make sure you lock in the filler using a high end...

Make sure you lock in the filler using a high end Wax or Sealant or it won't last very long! Once it wears out, give Scholl S30 a try! It's low cut and will remove light swirl marks permanently.
Forum: Waxes, Sealants & Paint Protection 04-06-2018, 10:46 PM
Replies: 54
Views: 11,518
Posted By BradleyW
Thanks. Can AG Tar Remover temporary soften...

Thanks.

Can AG Tar Remover temporary soften a car clear coat?

When I've removed the Wax, should I leave the car for a week before reapplying the Wax?

You mentioned the hazing is caused by...
Forum: Waxes, Sealants & Paint Protection 04-06-2018, 08:06 PM
Replies: 54
Views: 11,518
Posted By BradleyW
Thank you but unfortunately a QD only sorted the...

Thank you but unfortunately a QD only sorted the issue out for a day. The bloom reappeared.
Forum: The Showroom 01-06-2018, 01:12 AM
Replies: 10
Views: 1,517
Posted By BradleyW
That's a keeper!

That's a keeper!
Forum: Polish/Cleaners/Compounds/Glaze 30-05-2018, 06:38 PM
Replies: 8
Views: 938
Posted By BradleyW
Meg's M105 or Scholl S17+ for deep etching. ...

Meg's M105 or Scholl S17+ for deep etching.

Meg's M205 or Scholl S30 for low to mid etching.

Do at own risk.

I've heard someone on here say that Meg's ultimate compound did a great job at...
Forum: Pre-wash stages, Washing, Drying, Clay & 'Quick Detailing' 30-05-2018, 06:33 PM
Replies: 36
Views: 3,292
Posted By BradleyW
DoDo Juice Born To Be Mild. Wax safe, great...

DoDo Juice Born To Be Mild. Wax safe, great cleaning, slick, amazing suds, low dilution, no Wax or Gloss additives.
Forum: Detailing Chat 29-05-2018, 07:18 PM
Replies: 12,745
Views: 1,819,140
Posted By BradleyW
I've bought: BH Double Speed Wax CarPro BOA...

I've bought:
BH Double Speed Wax
CarPro BOA 350GSM MF (x2)
CarPro Iron-X

Should arrive tomorrow!
Forum: Detailing Chat 29-05-2018, 03:27 PM
Replies: 2
Views: 467
Posted By BradleyW
Looks pretty good!

Looks pretty good!
Forum: Polish/Cleaners/Compounds/Glaze 29-04-2018, 01:57 AM
Replies: 12
Views: 2,716
Posted By BradleyW
Scholl S17+. Hex Logic White. It will...

Scholl S17+.
Hex Logic White.

It will remove swirls, light to medium defects, marring, light to medium etching, water marks and buffering trails.

The S17+ is a diminishing abrasive. It cuts...
Forum: Detailing Chat 27-04-2018, 11:50 PM
Replies: 4
Views: 416
Posted By BradleyW
I think we should ask various companies about...

I think we should ask various companies about their Si02 percentages! I'd like to know how much is in HydrO2 LITE.
Showing results 1 to 25 of 47

 
Forum Jump

All times are GMT +1. The time now is 05:48 AM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
DTO Garage vBulletin Plugins by Drive Thru Online, Inc.

vB.Sponsors
Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
DTO Garage vBulletin Plugins by Drive Thru Online, Inc.

vB.Sponsors