View Single Post
Old 13-10-2007, 09:56 PM   #26
L200 Steve
Regional Organiser
 
L200 Steve's Avatar
 
Join Date: Oct 2005
Location: Leeds / Bradford
Posts: 4,116
Thanks: 71
Thanked 291 Times in 106 Posts
Quote:
Originally Posted by Epoch View Post
The pads are the Abrilon system and have about 5mm of foam on them. Thats the only flex but it wasn't so bad. You would have to be cautious.
I guess that we could have gone with a 3m intermediate pad between the dics and the sander if needed.

For a first run out with this bit of kit today I can already see that it has a huge potential in the right hands / on the right job.

You can get a consistent reduction in thickness over a set area with a lot more ease than any polisher that I have used to date.

I do feel that caution should be used though to prevent sand through.
L200 Steve is offline   Reply With Quote