Detailing World Forum banner

Maintenance of cquartz

3K views 6 replies 4 participants last post by  brett_hudson41 
#1 ·
I've just have car pro cquartz ceramic coating applied to my car.
I been advised to use ph neutral shampoo and snow foam

Will bilt hamber autofoam be ok to use can someone tell me.

Also can people give me any advise on maintaining the coating, the do's and donts of ceramic coating maintenance

Sent from my SM-G950F using Tapatalk
 
#3 ·
BH will be fine.

I would use Reset shampoo and maintain the coating with HydroFoam once month maybe.

Works for me, also look at Hydro2 and Reload.

Obviously don't skimp on the wash mitt and use 2 buckets.

Sent from my iPhone using Tapatalk Pro
Thanks mate. What wash mit would u say? That's not ridiculously priced. I already use the 2 buckets. I've read that u should avoid shampoos and other products with gloss enhancers, why is this?

Also, I use sonax BSD or OCD finish velocity as my quick detailer r these ok?

Sent from my SM-G950F using Tapatalk
 
#4 ·
Because it can (apparently) hide the gloss of the coat.

Personally I only use the Carpro system that was designed around/for the coating. Eg HydroFoam, HYDRO2 etc.

I really would try the Hydrofoam after the wash. Just spray in on and hose it off.

As for the mitt I use the Adams pad but the choice is huge.


Sent from my iPhone using Tapatalk Pro
 
#6 ·
Last 5 cars over a good number of years all c quartz I have BH Auto foam not an issue also valet pro citrus wash fine and also power maxed traffic film remover been ok, washing I use Reset know expensive but very good also used GWash and was fine as well.
I used to use hydro2 but know I just add a coat of reload know and again:thumb:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top