Detailing World Forum banner

Menzerna polish and seal, advice needed!

3K views 6 replies 2 participants last post by  Joel93 
#1 · (Edited)
So iv ended up with some menzerna products but it’s a mixed bad and I’m not sure how to go about using them .
All the cars I do are good condition daily drivers.
I have :
Menzerna 2500
Menzerna 3 in 1
Menzerna power lock .
So my plan is using the 2500 on a medium pad , then the 3 in 1 on a finishing pad , and finally after a few weeks as the 3 in 1 protection runs out I’ll add a top layer of power lock.

Is this the best way to use them ?

Ps. I have some poor boys black hole (which I love) is the suitable for use under power lock sealant ?
 
#2 ·
With the Menzerna 3in1 you won't need to use the 2500, as 3in1 already has the same cutting ability.

You're probably better off trying the 3in1 with the finishing pad first to see if it removes the defects required.

The protection from 3in1 will last around 4-6 weeks too and then you can top it with Powerlock.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top