View Single Post
Old 13-03-2018, 05:17 PM   #7
OCD Sufferer (Obsessive Car Detailer)
Sicskate's Avatar
Join Date: Oct 2012
Location: Margate
Posts: 3,545
Thanks: 3,012
Thanked 1,384 Times in 1,098 Posts
I wouldn't polish it up yet, it will look rubbish.

I don't really like to give advice as it's really hard to evaluate a chip from a picture.

Also different people have different ability's.

I guess at this point I'd suggest making sure the chip is flat, without any low spots.

When you use the blade, slide it over smoothly without any pressure. If it catches the chip, good. If not just keep going.

A single chip can still take me 20-30 slides to get smooth.

I can get you a few more pictures of different situations tomorrow if you like??
Sicskate is offline   Reply With Quote