Detailing World Forum banner

FK1000 on wheels...quick test

8K views 6 replies 5 participants last post by  THE CHAMP 
#1 · (Edited)
I detailed the car with FK1000 the other day, and also did the wheels.

1 week of daily use and a fair bit of dirt later, I thought I'd see how clean they come up with just a blast from the PW :D

Before



After




Video



Conclusion

These wheels came up 100% clean with just a quick blast of water. OK they weren't exactly filthy, but still had a fair amount of grime on them. This is as good or better than anything I have tried to date, so will monitor how long it stays like this - so far so good :thumb:
 
See less See more
1 3
#6 ·
1. good hit with AS Smart Wheels at 1:3
2. Tardis as required on a few tar spots
3. quick run over the insides with clay
4. shampoo wash & rinse
5. FK1000 x 2

The FK1000 is nice and easy to use on wheels as well. As it sort of melts into the applicator a bit, once you've done some on the paint, the applicator has enough in it that just a quick wipe over leaves a nice thin layer. Handy...

:D
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top